Amazon cover image
Image from Amazon.com

Modeling Using Pro/Engineer Wildfire / Sridhar S. Condoo

By: Material type: TextTextPublication details: St. Louis, MO : SDC, [2003]Edition: Release WIldfireDescription: 209 p. : ill. ; 21 x 27 cmISBN:
  • 1585031186
Subject(s):
Partial contents:
1. Introduction -- 2. Bearings -- 3. Bearings -- 4. Bushing -- 5. Retaining Ring -- 6. Shaft -- 7. Nuts and Bolts -- 8. Bolt Heads -- 9. Washington Monument and Wing -- 10. Springs -- 11. Axial Cam -- 12. Radial Plate Cam -- 13. Grooved Cam -- 14. Gateway Arch -- 15. Spur and Helical Gears -- 16. Shaft Drawing -- 17. Housing -- 18. Cam Assembly -- 19. Cam Follower Assembly -- 20. Electrical Fuse Assembly
Summary: This book synergistically integrates the design process with the specific commands and procedures of ProENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts
Star ratings
    Average rating: 0.0 (0 votes)
Holdings
Item type Current library Call number Status Date due Barcode
General General ATU Dublin Road General Shelves 620.0042 CON (Browse shelf(Opens below)) Available J125671

1. Introduction -- 2. Bearings -- 3. Bearings -- 4. Bushing -- 5. Retaining Ring -- 6. Shaft -- 7. Nuts and Bolts -- 8. Bolt Heads -- 9. Washington Monument and Wing -- 10. Springs -- 11. Axial Cam -- 12. Radial Plate Cam -- 13. Grooved Cam -- 14. Gateway Arch -- 15. Spur and Helical Gears -- 16. Shaft Drawing -- 17. Housing -- 18. Cam Assembly -- 19. Cam Follower Assembly -- 20. Electrical Fuse Assembly

This book synergistically integrates the design process with the specific commands and procedures of ProENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts

There are no comments on this title.

to post a comment.
Share