Modeling Using Pro/Engineer Wildfire /

Condoor, Sridhar S., 1967-

Modeling Using Pro/Engineer Wildfire / Sridhar S. Condoo - Release WIldfire - St. Louis, MO : SDC, [2003] - 209 p. : ill. ; 21 x 27 cm

1. Introduction -- 2. Bearings -- 3. Bearings -- 4. Bushing -- 5. Retaining Ring -- 6. Shaft -- 7. Nuts and Bolts -- 8. Bolt Heads -- 9. Washington Monument and Wing -- 10. Springs -- 11. Axial Cam -- 12. Radial Plate Cam -- 13. Grooved Cam -- 14. Gateway Arch -- 15. Spur and Helical Gears -- 16. Shaft Drawing -- 17. Housing -- 18. Cam Assembly -- 19. Cam Follower Assembly -- 20. Electrical Fuse Assembly

This book synergistically integrates the design process with the specific commands and procedures of ProENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts

1585031186


Pro/ENGINEER


Engineering design--Electronic data processing
Mechanical drawing
Computer-aided design